Brushes; Storage; Lubrication - Hoover FloorMate SpinScrub FH40010 Guide D'utilisation

brushes:

how to Change and Clean
The brush assembly can be removed for easy
cleaning.
CAUTION
!
To reduce the risk of injury from moving parts,
unplug cleaner before servicing.
how to remove
Place handle in the upright position.
Remove tanks to prevent leaking. Set aside.
4.6 Pull the two nozzle release buttons (A) out.
Remove nozzle.
Tilt cleaner back so handle rests on floor.
4.7 Push two brush release buttons (B) and remove
the brush assembly.
The brushes can be washed with a mild detergent
and rinsed. Do not use a solvent based detergent.
how to replace
4.8 To replace brushes, align post (C) on brush block
with hole (D) on bottom of cleaner. Turn brushes
slightly until post fits easily into hole. Press brush
assembly firmly to snap into place.
4.9 Return cleaner to upright position. Replace
nozzle, making sure latches (E) are out.
Align middle section (F) of nozzle with opening (G)
on cleaner.
4.10 While holding nozzle in place, slide latches
inward to lock in place.
Replace tanks.

storaGe

Before storing cleaner:
Turn cleaner OFF and disconnect from electrical
outlet.
• Empty and rinse solution and Dirty Water
Tanks. Allow to air dry.
• Press on upper handle release button to lower
handle for storage.
• Make sure that nothing is pressing on the
nozzle squeegee.
• Do not store cleaner on a wood surface unless
cleaner is completely dry.
4.6
A
!
4.8
C
4.10

lubriCation

The motor is equipped with bearings which contain
sufficient lubrication for the life of the motor. The
addition of lubricant could cause damage. do not
add lubricant to motor bearings.
12
4.7
A
4.9
d
F G
e
b
e