Scope Of Delivery; Accessories; Intended Use - Oase LunAqua Power LED Notice D'emploi

Scope of delivery

Fig. A LunAqua Power LED
Quantity
Set 1 Set 3
1 1 3
2 1 3
3 1 3
4 1 1
5 1 1

Accessories

• A total of 4 spotlights can be connected to the driver. The individual LunAqua Power LED W spotlight (
cifically intended to be used with Set 1/Set 3.
• The 10 m LunAqua Power LED cable (42636) is intended for extending the cable between a spotlight and the driver.

Intended use

LunAqua Power LED, referred to as "unit", may only be used as specified in the following:
• For use in water fountain systems and ponds.
• For use above and under water.
• Operate in accordance with instructions.
Permissible ambient temperatures for operating the driver and the spotlights
• Underwater installation: Water temperature of +4 °C to +35 °C.
• Dry installation: Air temperature of -10 °C to +40 °C.
Installation
 B
• The spotlight and driver can be installed in or outside of the water. The driver may not be installed in swimming ponds;
it must be installed outside of the water and at the specified distance away from swimming ponds.
• The spotlight can be mounted on a nozzle extension for illuminating a fountain.
• Use the supplied long Allen key for fitting if necessary.
A T T E N T I O N ! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into the
water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
Adjusting the tilt of the spotlight
How to proceed:
 C
Slightly loosen the fastening screws on both sides of the spotlight.
Tilt the spotlight as required.
Tighten the fastening screws again.
Installation with the ground stake
How to proceed:
 D, C
Fully insert the ground stake into the ground.
Fit the spotlight onto the ground stake.
Slightly loosen the fastening screws on both sides of the spotlight.
Tilt the spotlight as required.
Tighten the fastening screws again.
Description
W
1 LED spotlight including bulb
1 Fastening set
1 Ground stake
1 Allen key
"LunAqua Power LED Driver" driver with connection cable
- EN -
is spe-
42635)
13