What To Do If You Smell Gas; Operating Instructions; To Turn Off Gas To Appliance - Rinnai RU199i Manuel D'utilisation

WARNING
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights the
burner. Do not try to light the burner by hand.
B. BEFORE OPERATING, smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
1. STOP! Read the safety information above.
2. Set the temperature controller to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance does not have a pilot. It is equipped with
an ignition device which automatically lights the
burner. Do not try to light the burner by hand.
5. Turn the manual gas control valve located at gas inlet
of appliance clockwise
6. Wait five (5) minutes to clear out any gas. Then smell
Manual Valve
1. Set the temperature controller to lowest setting.
2. Turn off all electric power to the appliance if service is
to be performed.
8

Operating Instructions

FOR YOUR SAFETY READ BEFORE OPERATING
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
OPERATING INSTRUCTIONS
to the OFF position.
CLOSE OPEN

TO TURN OFF GAS TO APPLIANCE

Conversion Manual for Condensing Tankless Water Heaters
C. Use only your hand to push in or turn the gas control
valve. Never use tools. If the gas control valve will not
turn by hand, do not try to repair it, call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
for gas, including near the floor. If you smell gas, STOP!
Follow "B" in the safety information above. If you don't
smell gas, go to the next step.
7. Turn the manual gas valve located at gas inlet of
appliance counterclockwise
position.
8. Turn on all electric power to the appliance.
9. Set the temperature controller to desired setting.
10. If the appliance will not operate, follow the instructions
"To Turn Off Gas To Appliance" and call your service
technician or gas supplier.
3. Turn the manual gas control valve located at gas inlet
of appliance clockwise
to the full ON
to the OFF position.