Télécharger Imprimer la page

Breville NESPRESSO Vertuo Plus Mode D'emploi page 26

Publicité

TROUBLESHOOTING
EN
1. No light on the button.
2. No coffee.
3. Coffee is not hot enough.
4. Unusual coffee flow.
5. Water leakage.
6. Capsule is not ejecting correctly.
7. Coffee leakage.
8. Machine turns to "OFF" mode.
9. Coffee grounds in the cup.
GREEN LIGHT
10. The machine does not start and has GREEN steady lights.
11. GREEN light blinking continuously and machine not
running.
12. GREEN light turning while machine is running.
26
9465_UM_ARES_PLUS_C_Breville_Without-brewing.indd 26
ASSISTANCE VIDEOS ARE AVAILABLE ON
WWW.NESPRESSO.COM - VISIT THE "MACHINES" SECTION
The machine has turned "OFF" automatically; push the button to turn the machine "ON".
Check the plug, voltage, and fuse.
Check that the light on the button is GREEN.
Check that the water tank is filled and is well positioned.
Check that a fresh capsule is inserted in correct position, that the machine head is closed and push the button to start.
Descale if necessary.
Open the machine head and let the capsule be ejected. Then perform a cleaning as per cleaning section.
Preheat cup with hot water from the tap.
Descale if necessary.
Check that the water tank is well positioned.
Open the machine head and let the capsule be ejected. Then perform a cleaning as per cleaning section.
Descale if necessary.
Check that the water tank is well positioned.
Empty and clean the capsule container.
If problem persists, call the Nespresso Club.
Open the machine head. Remove the power cord from the grid. Clean the metallic
clamps with precaution. Be careful of the sharp edges in the machine head.
If problem persists, call the Nespresso Club.
Open the machine head and let the capsule be ejected. Then perform a cleaning.
Empty and clean the cup support.
Descale if necessary.
If problem persists, call the Nespresso Club.
To save energy the machine will turn off after 9 minutes of non-use.
See paragraph on "Energy Saving Concept".
Start the cleaning procedure. See paragraph on "Cleaning".
Check the machine head is properly closed.
If you want to brew an Alto, Coffee or Espresso, check that a fresh capsule is inserted in correct position, that the machine
head is properly closed and push the button to start.
The machine is heating up and it will take maximum one minute to be ready.
This indicates the machine is working properly.
26.09.16 17:17

Publicité

Chapitres

loading