Playing Records - auna TT-10 BT Mode D'emploi

Playing records

This system includes a full-size, 3-speed, belt-drive turntable. You can play 33, 45 & 78 rpm records
1. Power the unit and connect to external amplifier (ref to "PREPARING FOR USE" and "LINE OUT
OPERATION"
2. Place a record on the platter lightly. For the 45rpm record, use the adaptor for playing 45 rpm
record (included).
3. Select the speed of record: 33 1/3, 45 , 78 rpm by switch the speed switch according to the record
to be played.
4. Slect the auto stop switch: The turntable will stop automatically while the song on the record
finished when it is ON. Or the turntable will always play otherwise manually stop it when it is OFF,
this help to play some long recorded vinyl.
5. Remove the stylus guard and push the lift lever upward to raise the tone arm from the arm park,
and then move the cartridge holder over the record gently, now the platter will run automatically.
Then put down the lever and the tone arm would gradually descend and touch record surface, the
play will start.
6. Push the lift lever up to raise the tome arm to pause the record before its end up. Then put down
the lever forward to continue playing.
7. Adjust the volume with VOLUME control on the external amplifier.
Note:
• Do not turn or stop the turntable manually. Moving or Jarring the turntable without securing the tone
arm clamp could result in damage to the tone arm.
Line out / Connection BT transmitter
Preparation for use
1. Connect the unit to external power socket through the power adaptor included.
2. Push the output mode change button to change to Bluetooth transmitter. The BT name is "TT-10BT".
The LINE OUT/BLUETOOTH LED indicator will start flashing and pairing. Please make sure the
external Bluetooth amplifier is on and no other disturbing Bluetooth devices in the areas.
3. A Di-du sound will indicate successful connecting. And The LINE OUT/BLUETOOTH LED indicator
stop flashing. Play the record, and now adjust volume on the Bluetooth amplifier to your desired
level.
LINE OUT operation
"LINE OUT" jack is another way to connect with external amplifiers, specially traditional one. Make sure
that you connect the white plug to the white jack (left) and the red plug to the red jack (right).
Push the output mode change button to change to LINE OUT, The LINE OUT/BLUETOOTH indicator
goes off, now only LINE OUT output is available, play the record, and now you can enjoy music through
Bluetooth amplifier
13
www.auna.de