auna TT-10 BT Mode D'emploi page 14

Auto stop
1. Connect a speaker with the unit by LINE OUT jacks
2. Select the Record Speech using the 3- SPEED SELECTOR.
• For a 45 RPM record, please use included 45 Adaptor located in the top left
corner of the unit
3. Turn the speaker's VOLUME KNOB to adjust the volume.
4. Unlock the tone arm from the tone arm support.
5. Move the tone arm gently to the edge of the record (or the starting point of
a track).
• -The turntable will begin to turn .Be sure the stylus (needle) is secure.
• When the tone arm reaches the end of the record it will automatically stop.
6. Turn the speaker's VOLUME KNOB to adjust the volume.
Replacing the stylus
Under normal use, the stylus (needle) will last. However, it is recommended that the stylus be replaced
as soon as you notice a change in sound quality. Prolonged use of a worn-out stylus may damage the
record. The higher speed of 78RPM records can wear the stylus at a faster rate.
Notes
• Do not remove or bend the stylus.
• To avoid injury, do not touch the needle.
• Turn off the unit's power before you replace the stylus
• Keep out of the reach of children.
Removing the old stylus
1. Set a screwdriver at the tip of the stylus and push down
to the direction "A".
2. Pull the stylus out toward direction "B".
Installing a new stylus
1. Hold the tip of the stylus and insert the other edge by
pressing toward direction"C".
2. Push the stylus up toward direction "D" until it locks at
the tip.
14
Maintenance
www.auna.de