THOMSON TWBI3815FULL Manuel D'instructions page 51

Adjusting the salt consumption
1. Switch on the dishwasher.
2. Enter the status of salt consumption by holding down
(factory setting) appears on the display.
3. While the value shows on the display, repeatedly press
from H1 to H6 to suit the water hardness.
4. The setting will be validated automatically after a few seconds if you do not press
Program > again.
WATER HARDNESS
°dH °fH
0~5 0~9
6~11 10~20
12~17 21~30
18~22 31~40
23~34 41~60
35~55 61~98
NOTE:
1 °dH=1.25 ºClarke=1.78 ºfH=0.178mmol/l
°dH: German degree
°fH: French degree
°Clarke: British degree
Filling with salt
Unscrew the cap from the salt container by turning it anticlockwise.
Place the supplied funnel so the end fits into the opening of the salt container. Load
about 1.5kg of salt into the salt container.
Screw the cap back clockwise.
NOTE: The salt container must only be refilled when the refill salt indicator light
illuminates. Depending on how fully the salt dissolves, the refill salt indicator light
may still be on even though the salt container is filled.
°Clarke mmol/l
0~6 0~0.94
7~14 1.0~2.0
15~21 2.1~3.0
22~28 3.1~4.0
29~42 4.1~6.0
43~69 6.1~9.8
Program >
Program >
Salt consumption
Display
(gram/cycle)
H1
H2
H3
H4
H5
H6
until the value "H3"
to adjust the setting
0
9
12
20
30
60
18