THOMSON TWBI3815FULL Manuel D'instructions page 44

 After the furniture door has been fitted, you will need to adjust the tension of the
door spring.
 Use an Allen key (not supplied) to rotate the adjusting screw or either tighten or
loosen the steel cable.
 The spring tension is correct when:
a) The door remains horizontal in the fully opened position.
b) You are able to close the door easily.
WARNING: If the tension of the door spring is not adjusted, then it could cause
damage to the appliance.
Connecting to the Mains Water Supply
Inlet hose (Cold water supply)
The water inlet hose from the machine terminates in a 3/4" female connector. The
water supply should therefore terminate in a similar male connector and should
have a stopcock close by in the pipe.
Connect the straight connector of the inlet hose to the water supply
securely ensuring that the washers are securely in place at both
ends of the hose.
Water Pressure
For best operating results, incoming water pressure should be between 0.04 MPa
and 1MPa. Incoming water supply for the dishwasher is controlled by a 'pressure
switch', so if the household water pressure is low, dishwasher fill time will increase
or may not operate.
WARNING: Please close the hydrant after using.
Connecting to the water outlet
Insert the drain hose into a drainage pipe or standpipe.
The end of the hose should be dropped into a drainage pipe, the maximum height of
which should be
1000 mm above the base of the dishwasher. The end of the hose must not be
immersed in water to avoid the back flow of it.
To allow for an air gap around the end of the drain hose, the diameter of the
standpipe
should be at least 40 mm.
11