Status Led - Keba KeContact P20 Manuel De L'utilisateur

3

Status LED

Status LED
Flashes slowly green
every 3 sec-
onds
Lights up con- green
tinuously
Flashes every green
second
Lights up orange briefly after
plugging in
Lights up orange for approxi-
mately 5 seconds
Green LED goes out briefly ev-
ery 3 seconds
Flashes orange slowly every 5
seconds
Flashes red
Segment 2 lights up orange
24/200
Status LED
Status LED - segments
The status LED provides information about the current
operating state of the charging station. It consists of 4
segments (S1 to S4), which can light up or flash, to-
gether or individually, in various colors.
The status LED is only visible when the power is
switched on.
If not otherwise specified, all 4 segments light up to-
gether.
Function
Ready for operation (the charging cable is not yet plugged into the vehi-
cle;
Optional: The charging station was authorized correctly by key switch or
RFID card)
Ready for charging (charging cable is plugged in on both sides and
locked)
Charging procedure is being performed (applies for "EN 61851 Mode 3"
charging procedure)
Wait for locking (charging cable was plugged in and the system attempts
to lock the plug)
Self-test when plugging in and starting up the device.
Wait for unplugging (charging procedure complete, vehicle unplugged)
Temperature limit exceeded (charging procedure temporarily interrupted;
charging continues after cooling down)
Malfunction (for details, see Chapter
Commissioning mode
(the charging station is in commissioning mode)
"↪ 5 Troubleshooting [26]")