Basic Operation; Quitting The System - Pioneer DDJ-WEGO2 Guide De Démarrage Rapide

When using an iPhone/iPad
Audio disorders (beeping) may occur in this unit when calling or send-
ing/receiving data on the mobile phone. This problem can arise when
the mobile phone's communications protocol is GSM, and is due to
interference caused by GSM. If this happens, change the iPhone/iPad's
setting to flight mode.
This problem does not occur with the 3G or LTE communications
protocols.
1 Connect the iPhone/iPad with this unit using the
iPhone/iPad connection cable (Lightning).
2 Connect this unit with the USB mobile battery or USB
power adapter.
3 Slide this unit's [ON/OFF] switch to the [ON] position.
4 Launch the DJ application on the iPhone/iPad.

Basic Operation

D C C
Loading tracks and playing them (rA)
1 Turn the rotary selector while pressing the [SHIFT]
button to select a folder or item.
! When a folder or item with the [+] mark is selected and the rotary
selector is pressed while pressing the [SHIFT] button, that folder or
item is opened or closed.
2 Release the [SHIFT] button then turn the rotary
selector to select the track.
3 Press the [LOAD] button to load the selected track
onto the deck.
4 Press the [f] button to play the track.
! When this button is pressed again during playback, playback
pauses.
Using the mixer functions (rB)
! Adjust the volume of the powered speakers, etc., connected to the
[MASTER OUT] terminals to an appropriate level. Note that if the
volume is set too high, the output sound could be very loud.
1 Operate the channel faders to adjust the audio level
output from the respective decks.
2 Operate the crossfader to switch the deck whose
sound is output from the speakers.
— Left edge: Sound is output from deck [A] or [C].
— Center: The sound of all the decks is mixed and output.
— Right edge: Sound is output from deck [B] or [D].
A B D
B
! The curve characteristics can be switched using the crossfader
curve setting button on the [MIXER] panel at the center of the com-
puter's screen.
— [ ]: Select this when you do not want to use the crossfader.
— [ ]: Set here for a curve that rises gradually.
— [ ]: Sets an abruptly rising curve.
3 Turn the [MASTER VOL] control to adjust the audio
level of the speakers.
Monitoring sound with headphones (rC)
1 Connect headphones to the [PHONES] terminal.
2 Press the [CUE ] button for the deck you want to
monitor.
3 Turn the [HEADPHONES MIX] control.
! Turn counterclockwise: The volume of the deck whose [CUE
ton is pressed increases relatively.
! Turn clockwise: The [MASTER OUT] volume increases relatively.
4 Turn the [HEADPHONES VOL] control.
! The sound of the deck whose [CUE
from the headphones.
! When the [CUE ] button is pressed again, monitoring is canceled.

Quitting the system

1 Quit VIRTUAL DJ LE.
2 Slide this unit's [ON/OFF] switch to the [OFF] position.
3 Disconnect the USB cable from your computer.
] but-
] button is pressed is output
En
9