Frigidaire EFRB200 Manuel De L'utilisateur page 8

INSTALLING THE GUARDRAIL
Follow the steps below to install the guardrail.
1. Place the guard rail on top of the cabinet.
2. Align all support feet of the guardrail with the holes on the top of the unit and press down into
place.
CAUTION: Do not install the unit where the temperature will drop below 13°C
(55°F) or rise above 32°C (90°F). The compressor will not be able to maintain
proper temperatures inside the unit.
INSTALLATION
Installation clearances
• Allow the following clearances for ease of installation, proper air circulation, and electrical
connections:
NOTE: If your unit is placed with the door hinge side against a wall, you may have
to allow additional space so the door can be opened wider.
LEVELING
All four casters of your unit must rest firmly on a solid floor. Use adjustable wrench to adjust
leveling screws.
CAUTION: do not attempt to move or relocate the keg cooler with a keg inside.
REGULATOR INSTALLATION
• Check to ensure plastic washer is inside the hex nut.
• Fasten the CO regulator (6) to the CO
2
the regulator to the right of the tank.
• Tighten the hex nut securely. DO NOT over tighten. Over-
tightening may damage the gasket in the nut of the regulator.
SMALL CO HOSE TO REGULATOR CONNECTION
2
• Attach wing nut on end of small hose (8) to fitting at bottom of regulator (6).
Sides and Top
Back
canister (12). Place
2
7
12.7 cm (5 inches)
12.7 cm (5 inches)