Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Short Vacations
Long Vacations
Moving
NORMAL OPERATING SOUNDS AND SIGHTS
UNDERSTANDING THE SOUNDS YOU MAY HEAR
Your new, high-efficiency keg cooler may introduce unfamiliar sounds. These sounds normally
indicate your keg cooler is operating correctly. Some surfaces on floors, walls, and kitchen
cabinets may make these sounds more noticeable.
NOTE: Rigid foam insulation is very energy efficient, but is not a sound insulator.
Following is a list of major components in your keg cooler and the sounds they can cause:
Evaporator Refrigerant through the evaporator may create a boiling or gurgling sound.
Electronic control and automatic defrost control These parts can produce a snapping or
clicking sound when turning the cooling system on and off.
Compressor Modern, high-efficiency compressors run much faster than in the past. The
compressor may have a high-pitched hum or pulsating sound.
Drain pan (not removable) You may hear water dripping into the drain pan during the defrost
cycle.
ENERGY SAVING TIPS
• Install the keg cooler in the coolest part of the room, out of direct
sunlight and away from heating ducts or registers. Do not place the keg
cooler next to heat-producing appliances such as a range, oven, or
dishwasher.
• Do not overcrowd the keg cooler or block cold air vents. Doing so
causes the keg cooler to run longer and use more energy.
• Organize the keg cooler to reduce door openings. Remove as many
items as needed at one time and close the door as soon as possible.
VACATION AND MOVING TIPS
Vacation and Moving Tips
•
Leave keg cooler operating during vacations of three (3) weeks or less.
•
Use all perishable items from keg cooler compartment.
•
Remove all food and ice if you will be gone one month or more.
•
Turn controls to the OFF position and disconnect power.
•
Clean interior thoroughly.
•
Leave door open to prevent odours and mould build-up. Block door open if necessary.
•
NEVER MOVE KEG COOLER WITH KEG INSIDE.
•
If using handcart, load from side.
•
Adjust leveling legs all the way up to protect
•
Pad cabinet to avoid scratching surface.
surface during sliding or moving.
15
Publicité
Chapitres
Table des Matières
