Frigidaire EFRB200 Manuel De L'utilisateur page 10

CO CANISTER TO CABINET INSTALLATION
2
• Lift and place the CO
corner of cabinet. It is important that the canister be kept in an upright position to operate
efficiently. Hook one end of retaining strap (3) over metal bracket at rear, then stretch around
canister and hook other end over front bracket.
KEG TO CABINET INSTALLATION
• Place the keg on the support shelf and push
back next to the CO
INSTALLING KEG TO THE CABINET) inside the
cabinet as shown.
WARNING
SAFE KEG HANDLING
• Installing the keg to the cabinet is a two-person team effort. NEVER lift a full keg alone.
Doing so may cause severe injury.
• With the door fully open and the help of another person, lift the keg vertically on both
sides until the keg is higher than the keg support shelf.
• Set the edge of the keg on top of the plastic protective plate located on top of keg
support shelf. Slide the keg back until it is fully inside the cabinet.
• Care must be taken to avoid damage to the temperature control and shelf tower located
in the cabinet.
NOTE: The above illustration does not show the tap installed for clarity of installation.
canister (12) with the CO
2
canister (12) (See TIPS ON
2
regulator (6) on the shelf at rear right hand
2
9