Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONCERN
RUNNING OF KEG COOLER
Keg cooler does not
run.
Keg cooler runs too
much or too long.
Interior keg cooler tem -
perature is too cold.
Interior keg cooler
temperature is too
warm.
Keg cooler external
surface temperature is
warm.
WATER/MOISTURE/FROST INSIDE KEG COOLER
Moisture collects on
inside of keg cooler
walls.
WATER/MOISTURE/FROST OUTSIDE KEG COOLER
Moisture collects on
outside of keg cooler
walls.
ODOUR IN KEG COOLER
Unpleasant odours.
DOOR PROBLEMS
Door will not close.

BEFORE YOU CALL

POTENTIAL CAUSE
Keg cooler is plugged into a
circuit that has a ground fault
interrupt.
Temperature control is in the
"O" position.
Keg cooler may not be plugged
in, or plug may be loose.
House fuse blown or tripped
circuit breaker.
Power outage.
Room or outside weather is
hot.
Keg cooler has recently been
disconnected for a period of time.
Doors are opened too frequently
or too long.
Keg cooler door may be slightly
open.
Temperature control is set too
low.
Keg cooler gasket is dirty, worn,
cracked, or poorly
fitted.
Temperature control is set too
low.
Temperature control is set too
warm.
Door is kept open too long or is
opened too frequently.
Door may not be seating properly.
Keg cooler has recently been
disconnected for a period of time.
The external walls can be as
much as -1
C (30
F) warmer
O
O
than room temperature.
Weather is hot and humid.
Door may not be seating
properly.
Door is kept open too long or
opened too frequently.
Door may not be seating
properly, causing the cold air
from inside the keg cooler to
meet warm moist air from the
outside.
Interior needs to be cleaned.
Keg cooler is not level.
COMMON SOLUTION
Use another circuit. If you are unsure about the outlet,
have it checked by a
See SETTING THE TEMPERATURE CONTROL section.
Ensure plug is tightly pushed into outlet.
Check/replace fuse with a 15 amp time-delay fuse. Reset
circuit breaker.
Check house lights. Call local electric company.
It's normal for the keg cooler to work longer under these
conditions.
It takes four (4) hours for the keg cooler to cool down
completely.
Warm air entering the keg cooler causes it to run more.
Open door less often.
See DOOR PROBLEMS section.
Adjust temperature control to warmer setting. Allow
several hours for temperature to stabilize.
Clean or change gasket. Leaks in door seal will cause keg
cooler to run longer in order to maintain desired temperatures.
Adjust temperature control to a warmer setting. Allow
several hours for temperature to stabilize.
Adjust temperature control to a colder setting. Allow
several hours for the temperature to stabilize.
Warm air enters the keg cooler every time the door is
opened. Open the door less often.
See DOOR PROBLEMS section.
It takes four (4) hours for the keg cooler to cool down
completely.
This is normal while the compressor works to transfer heat
from inside the keg cooler.
This is normal.
See DOOR PROBLEMS section.
Open the door less often.
See DOOR PROBLEMS section.
Clean interior with sponge, warm water, and baking soda .
This condition can force the cabinet out of square and
misalign the door. Level the unit .
17
certified
technician.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Efrb200c

Table des Matières