Frigidaire EFRB200 Manuel De L'utilisateur page 11

DELIVERY HOSE ARRANGEMENT
NOTE: Failure to route hoses properly may cause the hose to become kinked or
caught in door.
OPERATING YOUR KEG COOLER
• Make sure that the keg cooler is plugged in properly to a 115V, 60Hz AC only electrical outlet.
• Make sure that the drip tray and sump are secured under the faucet.
• Start with a clean beverage glass that has been wetted in cold water. Place the glass at a 45º
angle, 2.5 cm (1 in.) below the faucet. Do not let the glass touch the faucet. Open the faucet
all the way.
• After the glass has reached half full, gradually bring the glass to an upright position.
• Let the remaining beverage run straight down the middle. This insures proper release of CO
by producing a 1.9 to 2.5 cm (3/4 to 1 in.) foam head.
• Close the faucet completely and quickly.
NOTE: It is normal to see condensation forming around the faucet. This
condensation is caused by the temperature difference between the cold beverage
and the inner surfaces of the faucet when beverage is being drawn through the line.
10
2