Frigidaire EFRB200 Manuel De L'utilisateur page 19

CONCERN
SOUND AND NOISE
Louder sound levels
whenever keg cooler
is on.
Longer sound levels
when compressor
comes on.
Popping or cracking
sound when compres-
sor comes on.
Bubbling or gurgling
sound like water boil -
ing.
Vibrating or rattling
noise.
Snapping noise.
COMMON DRAFT PROBLEMS
WILD BEER - Beer,
when drawn, is all
foam, or too much
foam and not enough
liquid beer.
FLAT BEER - Foamy
head disappears
quickly; beer lacks
usual zestful brewery
fresh flavour.
CLOUDY BEER - When
beer in glass appears
hazy, not clear.
POTENTIAL CAUSE
• Modern keg coolers have in-
creased storage capacity and
more stable temperatures. They
require a high-efficiency compres-
sor.
• Keg cooler operates at high
pressure during the start of the
"ON" cycle.
• Metal parts undergo expansion
and contraction, as in hot water
pipes.
• Refrigerant (used to cool keg
cooler) is circulating throughout
the system.
• Keg cooler is touching the wall.
• Temperature control turning keg
cooler on and off.
• Beer drawn improperly.
• Creeping regulator.
• Applied pressure is set too high.
• Hot spots in line.
• Tapped into a warm keg (should
be 1.1 -3.5 -38
°C °C °F
（34
• Centre malfunctioning.
• Faucet is in bad, dirty or worn
condition.
• Dirty glasses.
• Applied pressure is set too low.
• CO
is cut off.
2
• Beer too cold.
• Loose tap or vent connections.
• Sluggish regulator.
• Frozen or near frozen beer.
• Unrefrigerated beer for long periods
of time.
• Dirty glasses.
• Dirty faucet.
• Unrefrigerated foods placed on top
of cold keg.
COMMON SOLUTION
• This is normal. When the surrounding noise level is low, you
might hear the compressor running while it cools the interior.
• This is normal. Sound will level off or disappear as the keg
cooler continues to run.
• This is normal. Sound will level off or disappear as the keg
cooler continues to run.
• This is normal.
• Move keg cooler slightly away from the wall.
• This is normal.
• Make sure faucet is opened all the way. Close quickly when
done.
• Replace with a new regulator.
• Readjust regulator to a lower pressure until foam subsides.
When pressure is properly set, you should be able to pour 10
oz. of beer in
• Make sure beer delivery line is not pinched and is fully inside
the interior of the keg cooler.
• Wait until keg cools down to proper temperature.
°F
）
• Have keg cooler serviced to return it to proper operating
condition.
• Thoroughly clean faucet with recommended cleaning kit.
Replace all worn seals.
• Wash glasses using soap-free detergent.
• Increase pressure until beer
second.
• Do not turn off CO
ready to be removed.
• Increase temperature of keg cooler. See SETTING THE
TEMPERATURE CONTROL section.
• Check that coupler is properly installed in keg.
• Replace regulator.
• Return keg to place of purchase and exchange for one that
has been properly refrigerated.
• Exchange keg for fresh one.
• Wash glasses using soap-free detergent.
• Clean faucet with recommended cleaning kit.
• Remove items from atop keg and place in a separate refrig-
erator.
18
five (5) seconds.
flows at a rate of 2 oz. per
supply line to keg until keg is empty and
2