Final Installation Checklist; Servicing - GE Zoneline AZ95E Mode D'emploi

Installing the Zoneline
11. Install Unit-Mounted Filter
Note: Use only one filter in the installation
• For installs that will use a unit-mounted filter, slide
it down between the provided filter brackets on the
front of the unit, ensuring that any airflow direction
arrows on the filter are pointing toward the unit.
• For installs that will employ a filter withing the return
return air grille kit for proper filter installation.
12. Install Air Return Grille or
Access Cover
instructions that came with the selected kit.
RAVRG4 - Access panel with return air grille
RAVRG2B - Return air grille
13. FINAL INSTALLATION
CHECKLIST
clearances around the unit have been adhered to
accessories have been installed properly and that
they have not been damaged during the installation
process.
calked.
and outdoor coil are free from any obstructions.
the system.
they are connected and adequate for the removal
of condensate water and that they meet approval of
the end user.
outlet.
13. FINAL INSTALLATION
CHECKLIST (cont)
supply circuit wire size have been sized correctly.
single circuit and is properly grounded.
with all applicable national and local codes and
14. Connect Power
checked and are correct, turn the power ON to the
unit at the main service panel.
ON and check the unit to make
sure it is functioning as intended.
15. Auxiliary Control Setting, if
required
instructions on how to program the controls.
Prior to programming the controls, review the final
installation checklist before applying power to the unit.

SERVICING

WARNING
Risk of Electric Shock, can
cause injury or death.
power OFF at the service panel and lock the area to
prevent power from being switched on accidentally.
When the area cannot be locked, securely fasten a
prominent warning device, such as a tag, to the
service panel.
NOTE: We strongly recommend that any servicing be
performed by a qualified individual.
To remove the unit from the closet.
OFF unit at electrical disconnect.
connect kit from unit.
5. Disconnect the wall thermostat wiring from the unit.
Before servicing, switch
OFF.
49-5000561 Rev. 1