Output Edit Menu - Ecler DAM514 Notice D'utilisation

8. OUTPUT EDIT MENU

To open the edit menu for the settings of an output, you have to press SHIFT + OUTPUTn,
OUTPUTn being the OUTPUT key corresponding to the desired output (ZONE A, B, C or D).
Once in the edit menu for an output, and in one of its pages, it is possible to obtain the same
page for another output by pressing SHIFT + OUTPUTm, OUTPUTm being the OUTPUT key for the new
targeted output.
The new edited values are activated in real time. You can cancel an edit operation, returning the
value before editing, by pressing SHIFT + CANCEL.
To exit the Edit menu and return to the main screen:

Press SHIFT + EXIT

Press SHIFT + OUTPUTn (the OUTPUT key of the output currently edited)

Stay 2 minutes without operating any control on the front panel
The next page shows the full structure and options of the menu for setting outputs.
Notes:
1. The crossover filter applied to each output can be of high-pass (HP) or low-pass (LP) type,
both with a Butterworth profile and a slope of 12 dB/octave, and a cut-off frequency adjustable
between 20 Hz and 20 kHz
2. The graphic equalizer applied to each output has a setting of ±10 dB for each of the 10
available bands:

31.5 Hz

63 Hz

125 Hz

250 Hz

500 Hz

1 kHz

2 kHz

4 kHz

8 kHz

16 kHz
3. The COPY FROM – PASTE TO operation copies all the settings from the source output to the
destination output, except for its name (LABEL)
20