Brevi Kio 539 Mode D'emploi page 15

Dear Client, thank you for choosing a Brevi product.
The car seat KIO Brevi conforms to ECE R44/04 for the Group 1, for children with a weight from 9 kgs to 18 kgs.
All ages given are approximate because all children grow at different rates, the weights given are the main safety issue.
WARNING
• This is a "universal" child restraint. It is approved to ece regulation 44.04 for general use in vehicles and will fit most, but not all,
car seats.
• A correct fit is likely if the vehicle manufacturer has declared in the vehicle hand book that the vehicle is capable of accepting
"universal" child restraint for this age group.
• This child restraint has been declared "universal" under more stringent conditions than those applied to earlier designs which
do not carry this notice.
• If in doubt, contact either the child restraint manufacturer or the retailer.
Only suitable if the vehicle is fitted with a 3-point static or 3-point retractor seat belts, approved to un/ece no. 16 or other equivalent
standards.
IMPORTANT
Attention: the car seat KIO Brevi can EXCLUSIVELY be installed in forward facing (fig. C) on the front
passenger seat or on the back seat (fig. B) and it has ALWAYS to be fixed with the 3 points seat belt
(fig.D).
Should your vehicle be equipped with front airbag, please observe any instructions in the vehicle
owner's manual.
Do not install KIO Brevi backward facing, or sideways facing.
It's recommended to use of the back seat on the opposite side to the driver.
In case of installation on front passenger seat, it's recommended to position the seat as far as possible from the dashboard.
The operations of assemblage and installation of KIO Brevi must be made by adults.
The operations of assemblage and installation, must be made without the presence of the child in the car seat.
It's important to respect the correct passages of the belts. Do not ever pass or fasten the seat bests in a different way than shown
in this user manual.
The car seat can be installed on the front passenger seat if it is equipped with a 3 point safety belt.
The installation of the car seat on the central back seat is possible if the seat is equipped with a 3 point safety belt.
Never leave the child in the car seat with the safety belts fastened unattended.
Regularly check, during the moves in the car, that your child and the car seat are correctly positioned and that the car seat is firmly
and correctly fixed.
RECOMMENDATIONS
1. The car seat always has to be installed with a rewindable or fixed 3 point safety belt, also when it is not used. A seat that is not
fixed could cause wounds to the other passengers in case of abrupt braking.
2. The car seat is only adapted to be used in vehicles equipped with rewindable or fixed 3 point safety belt, in compliance to safety
standard UN / ECE n°16 or other equivalent standards.
3. Verify that the car seat , once installed and ready to the use, is not jammed from an any mobile part of the seat or the car door.
4. Always check that the safety belt is in tension pulling upwards the diagonal line and always verify that it doesn't result entan-
gled.
5. In case of emergency, to quickly free your child from the safety belts of the car seat press the red button set on the buckle.
If subjected by an accident the car seat HAS TO BE changed by a new one. Even if there are no
signs of damage the violent stresses to which it is subjected in these cases can alter its structure
and solidity, thus compromising its safety and the safety of your child.
6. To guarantee the maximum safety and the correct protection of your child, do not to use or purchase a second-hand car seat.
No change or addition should be made to the seat without specific approval of the retailer.
7. Do not leave the car seat exposed to the sun to avoid that the child burns himself. Do not leave the car seat in the car in the sun:
ENGLISH
GB
15