Carrier RG05 Manuel D'utilisation page 5

BUTTONS
3. BUTTONS
AUTO
TEMP.
COOL
E
SET
DRY
CLOCK
HEAT TIMER
HOUR ON OFF
FAN
MODE FAN SPEED
M
SWING V SLEEP TIMER ON
2
SWING H IONIZER TIMER OFF
SELF CLEAN CLOCK
RESET LOCK
3
AUTO CLEAN
4
OPEN
07
11
TURBO / IONIZER Button
Active/Disable TURBO function for each press.
Turbo function enables the unit to reach the
preset temperature at cooling or heating
operation in the shortest time(if the indoor unit
does not support this function, there is no
corresponding operation happened when
pressing this button.)
Press the button more than 2 seconds, the
IONIZER function will be activated, press
it more than 2 seconds again to disable.
When the ionizer function is initiated, the
Ionizer / Plasma Dust Collector(depending on
models) is energized and will help to remove
pollen and impurities from the air.
12
LED Button
Press this button to clear or light the display on
the indoor unit.
13
RESET Button
Press the RESET button to cancel the current
setting. The remote controller will return to the
initial settings.
14
LOCK Button
Press this button to lock all the current settings,
and the remote controller will not accept any
operation except LOCK. Press the button again
to cancel this function.
OPERATION
4. OPERATION
AUTO
TEMP.
COOL
E
SET
DRY
CLOCK
HEAT TIMER
HOUR ON OFF
FAN
MODE FAN SPEED
M
SWING V SLEEP TIMER ON
SWING H IONIZER TIMER OFF
SELF CLEAN CLOCK
RESET LOCK
AUTO CLEAN
OPEN
Before start operating the air conditioner, set the
clock of the remote controller as following steps.
The clock panel on the remote controller will
display the time regardless of whether the air
conditioner is in use or not.
Initial Setting the Clock
After batteries are inserted in the remote controller,
the clock panel displays "12:00" and begin to flash.
UP/DOWN button
Press these buttons to set time.
Forward.
Backward.
Each time you press the button, the time moves
forward or backward by one minute. The time
alters as you push the button.
Keep pressing the button without releasing, the
time moves forward or backward by 10 minutes
CLOCK button
When the right time is achieved, press the CLOCK
button and wait for 5 seconds, the clock time stops
flashing and the clock starts operating.
Reset the Clock
Press the CLOCK button on the remote controller,
the time of the clock display will start to flash. To
set the new time, follow 1 and 2 of "Initial Setting
of the Clock".
Note: The time of the CLOCK must be set before
the AUTO-TIMER feature will operate.
* Clock accuracy is within 15 seconds per day.
08