Resetting Thermal Protection - Waring Commercial MX1300XTEE Mode D'emploi

NOTE: The STANDBY
restoring default programs is confirmed.
Your blender is equipped with a drink counter to keep track of daily drink
totals and total drink counts for your machine. To display the counts, hold
program buttons
will read:
DAILY COUNT XXXX
TTL COUNT XXXXX
Daily Count will display the numbers of drinks mixed per day. Total Count
is the total of all drinks made since first use of the blender. The Daily
Count can be reset by pressing and holding program buttons
simultaneously for 3 seconds, then pressing STANDBY button for
3 seconds. Daily Count will reset to zero and Total Count will remain
unchanged.
If Total Count needs to be reset, call your nearest Waring authorized service
facility for information.
NOTE: Use of the PULSE features will not add to the daily or total drink
counts.
• Your blender is equipped with an automatic reset switch to protect the
motor from overheating.
• If you blender stops running under heavy use, turn the power switch to
Off and unplug the power cord. Empty the blender container of all
its contents and allow approximately 5 to 10 minutes for the motor to
cool down.
• Plug the power cord back into the outlet and continue blending.
• If your blender does not function properly following this procedure,
discontinue use and contact a certified Waring Customer Service Center.
IMPORTANT – HOT BLENDING INSTRUCTIONS
To minimize the possibility of being scalded when blending hot materials, the
following precautions and procedure must be observed.
• Hot materials are those which are 100°F (38°C) or hotter.
• Limit the amount of materials processed to 1 pint, (473.1 ml.)
• Completely remove the center portion of the two-piece container lid before
starting motor (this will allow venting of the rapidly heated and expanded
air inside the container when blender is running).
• Always start blending on lowest speed setting, and then progress to
desired speed.
key will abort this process at any point before
DRINK COUNTER
& simultaneously for 3 seconds. Your display

RESETTING THERMAL PROTECTION

8
&