Resetting Thermal Protection - Waring Commercial MX Série Mode D'emploi

Your reprogrammable blenders are equipped with a drink counter to keep
track of daily drink totals and total drink counts for your machine. To display
the counts, hold program buttons
Your display will read:
DAILY COUNT XXXX
TTL COUNT XXXXX
Daily Count will display the numbers of drinks mixed per day. Total Count
is the accumulation of all drinks made since first use of the blender.
The Daily Count can be reset by holding in Program buttons
simultaneously for 3 seconds then, pressing ON/OFF button for 3 seconds.
Daily Count will reset to zero and Total Count will remain unchanged.
If Total Count needs to be reset, call your nearest Waring authorized service
facility for information.
NOTE: Use of the PULSE features will not add to the daily or total drink
counts.
• The blender you have purchased is equipped with an Automatic Reset
Switch to protect the motor from overheating.
• If your blender stops running under heavy use, turn the power switch to the
STANDBY or OFF position and unplug the power cord. Empty the blender
container of all its contents and allow approximately 5 minutes for the
motor to cool down.
• Plug the power cord back into the outlet and continue blending.
IMPORTANT - HOT BLENDING INSTRUCTIONS
To minimize the possibility of being scalded when blending hot materials,
the following precautions and procedure must be observed.
• Hot materials are those that are 100°F (38°C) or hotter.
• Limit the amount of materials processed to 1 pint.
• Completely remove the center portion of the two-piece container lid before
starting motor (this will allow venting of the rapidly heated and expanded
air inside the container when blender is running).
• Always start blending on lowest speed setting, and then progress to
desired speed.
• Never stand directly over blender when it is being started or while it
is running.
DRINK COUNTER

RESETTING THERMAL PROTECTION

& simultaneously for 3 seconds.
9
&