Resetting Thermal Protection; Cleaning And Sanitizing Instructions - Waring Commercial BLADE BB300 Serie Directives D'utilisation

the container on the motor base or remove it from
the motor base while motor is running.
8. A lways hold jar with one hand when starting and while
blending. Never operate without jar lid.
9. W ash and dry jar after each use. See Cleaning and
Sanitizing Instructions.
10. Unplug to turn off all power to blender.

RESETTING THERMAL PROTECTION

• Y our blender is equipped with a manual reset switch to
protect the motor from overheating.
• I f your blender stops running under heavy use, press the
ON/OFF button and unplug the power cord. Empty the
blender jar of all its contents and allow approximately
5 to 10 minutes for the motor to cool down.
• P lug the power cord back into the outlet and continue
blending.
• I f your blender does not function properly following this
procedure, discontinue use and contact a certified Waring
Customer Service Center.

CLEANING AND SANITIZING INSTRUCTIONS

THE JAR MUST BE CLEANED AND DRIED AFTER EACH
USE OF THE BLENDER ACCORDING TO THE FOLLOWING
INSTRUCTIONS.
FAILURE TO DO SO MAY ALLOW RESIDUE OF
PROCESSED MATERIAL TO COLLECT ON THE INTERNAL
SEALS OF THE BLADE ASSEMBLY, RENDERING THEM
INEFFECTIVE.
• W ash, rinse, sanitize and dry jar prior to initial use and
whenever it will not be used again within a period of
1 hour.
• Wash and rinse container after each use.
• C lean and sanitize motor base prior to initial use and after
each use.
8