Sonosax Stelladat II Manuel De L'utilisateur page 87

Procedure to perform a Pic reset (power manager micro-controller)
Please follow those steps:
1. Remove the bottom cover (6 screws)
2. Remove the 4-tracks board, which is held on the main board by two connectors
3. Short-circuit on the main board the two Pic reset contacts (two soldering points)
4. Put the 4-tracks board back in its place
5. Screw the bottom cover
These two
soldering points
must be short-
circuited.
Small SMD
capacitor
Main
board
4-tracks board to
be removed
Pin 2
PIC