Recording Only One Track - Aiwa XR-MR5 Mode D'emploi

RECORDING ONLY ONE TRACK

PUSH EJECTz
f,g
s
c
AUTO.F(RW)
MANUAL.F
CD
zCD-R/RW
OPEN/CLOSE
DISPLAY
1 Load a CD-R or CD-RW in the CD-R/CD-RW player/
recorder.
Load the disc with the label side up. To open or close the disc
tray, press z CD-R/RW OPEN/CLOSE.
2 Press CD and load a CD to be recorded in the CD
player.
Press the PUSH EJECT z position to open the disc
compartment and load the disc with the label side up. Then
close the disc compartment.
Wait until the unit finishes reading the loaded discs. (Make
sure the "CD-R" or "CD-RW" indicator lights up, and the total
number of tracks and total playing time of the CD are displayed.)
3 Play the track to be recorded.
Press f or g to select the track and press c.
Alternatively, press the numbered buttons on the remote control.
4 For manual finalizing recording, press MANUAL.F
on the main unit or on the remote control.
For auto finalizing recording (only for a CD-RW),
press AUTO.F (RW) on the main unit or AUTO.F on
the remote control.
CD playing returns to the beginning of the current track and
recording begins.
Recording stops automatically when the selected track finishes
playing.
When recording finishes, the "CD-R/RW REC" indicator disappears
in the display.
The CD play continues to the next track.
To stop the CD play, press s.
20
ENGLISH
To stop recording before the end of the track
Press s. Recording stops.
To stop play of the CD, press s again.
To record on a previously recorded CD-R or CD-RW
If there is an unrecorded section left on the CD-R or CD-RW, the
new recording automatically starts from where the previous
0-9,+10
DISPLAY
recording finished. If you want to start recording from the beginning
f,g
of a previously recorded CD-RW, erase the previous recording
CD
completely. (See page 24.)
A finalized* CD-R or a finalized CD-RW, however, cannot be
recorded on.
* See "FINALIZATION" on page 23.
To change the display during recording
s
Press DISPLAY on the main unit or press DISPLAY while pressing
c
SHIFT on the remote control. (See page 31 for details.)
MANUAL.F
AUTO.F
SHIFT
NOTE
You can change from auto finalizing recording to manual finalizing
by pressing MANUAL. F before recording is completed.
To do the opposite, similarly press AUTO.F (RW).