Periodic Maintenance Chart - Mi-T-M Corporation GEN-6000-0MYE Manuel D'opération

Masquer les pouces

Table des Matières

Les langues disponibles

5. Blow air through both elements using 42-7 psi

compressed air to remove the particulates. Use the

lowest possible air pressure to remove the dust without

damaging elements.

6. if either element is damaged replace both of them (they

are not sold individually).

7. Clean the inside of the air cleaner cover.

8. install the air cleaner element into the air cleaner

case.

9. Slide the outer foam element over the air cleaner

element.

0. install the wing nut and hand tighten. Overtightening the

wing nut will damage the air cleaner assembly.

. install the air cleaner cover.

2. install the wing nut and hand tighten. Overtightening the

wing nut will damage the air cleaner assembly.

Check fuel

Check engine oil

Check for loose or lost nuts and bolts

Check for leaks

Check cylinder and head fins for

dust and dirt

Check battery electrolyte level

Check fuel lines (replace if necessary)

Clean air cleaner foam element (**)

tighten nuts and bolts (*)

Change engine oil (*)

Clean fuel filter

replace air cleaner paper element (**)

Clean dust and dirt from

cylinder and cylinder head fins (**)

add fuel stabilizer

run unit dry

* Perform these operations after the first 5 hours of use, then at the recommended intervals.

** Service more frequently under dusty conditions.

NotE: These items must be performed with the proper tools. See your Mi-T-M Customer Service Repre-

sentative for service, unless you have the proper equipment and mechanical proficiency.

Service