Troubleshooting; Rdm - Robert Juliat 360LF CW Manuel

6 Troubleshooting

SYMPTOMS
Display
switches on
when button
is pressed
Display OFF
Display still
off when
button is
pressed
System and data display 7
switched on in red
Data display
The unit
7 switched
cannot
on in red
controlled
via DMX
Data display
(inactivated
7 switched
wireless
on in green
DMX)
When using several units,
dimming are not
synchronized
Light switches on when
powered on
Light switches on when
using the control board
Strobe function doesn't work
7

RDM

(function available soon – application update)
Available :
POSSIBLE REASONS
Display auto off mode
activated
No power
Problem with the DMX512
received signal and/or system
default – details available in
4/6 Fixture Tools menu
DMX protocol problem
Data cabling problem
DMX address
The strobe is active and the
channel value is void
Different resolution
Different smoothing
Different dimming curve
Manual value is operating
when DMX is not connected
Use of the Focus mode
Strobe function inactive
- 24 -
SOLUTIONS
Fixture Setup menu & Auto-Off (see 4.7.2)
Check :
power supply
•
thermal protection
•
the power supply connector must be
•
properly interlocked
Failure details are available in DMX Setup
menu
Check data signal
Check cabling and data
connectors
Check the DMX
address
The value must be 255 (100%) in order to
have the light intensity dimmed
Adjust all units to have the same coarse
dimming result (See 4.7.2 menu Fixture
Setup & Mode)
Adjust all units to have the same fine
dimming result (See 4.7.2 menu Fixture
Setup & Smoothing)
All the units must have the same dimming
curve (See 4.7.2 menu Fixture Setup &
Curve)
Fixture Setup & Local Value must be at zero
See 4.1.2
Strobe must be activated in menu Fixture
Setup & Mode & 16Bits+Strobe
EN
The received data
protocol can be
checked in the
DMX Setup &
Protocol menu