Black & Decker FSH10SM Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
Attaching the hose and accessories (Fig. A & B)
Warning! Inspect the seal (2a) on the steam nozzle (2) and
hose (3) before each use. If the seal is missing or damaged
then please contact your nearest authorised repair agent. Do
not use the appliance.
Attaching the hose (Fig. A)
Press in the clips (3a) on either side of the hose (3).
u
Press the hose (3) onto the steam nozzle (2) and release
u
the clips (3a).
Important! Ensure that the hose (3) is securely fastened
before using SteaMitt
. If steam escapes from the joint then
TM
the SteaMitt
is not correctly fitted, allow the unit to cool then
TM
remove and re-fit the hose.
Removing the hose and accessories (Fig. A & B)
Warning! The Steam nozzle, hose and SteaMitt
during use.
Allow the unit and all attachments to cool before removing.
Removing the hose (Fig. A)
Press in the clips (3a) on either side of the hose (3) and
u
pull away from the steam nozzle (2)
Filling the water tank (Fig. C)
Note! Fill the water tank with clean tap water. Donot use
chemicals or any other additives.
Note! In areas of very hard water, the use of de-ionised water
is recommended.
Switch off the unit and disconnect from the mains supply.
u
Open the filler cap (7) by flipping it up.
u
Fill the water tank (6) with water.
u
Warning! Your water tank has a 0.10 litre capacity. Do not
over fill the tank.
Replace the filter cap.
u
Note: Ensure the filter cap is firmly secured.
Note: Do not use chemical cleaners with your SteaMitt
Fitting the cleaning pad (Fig. B)
Fit the cleaning pad (9) to the SteaMitt
u
the 'loop' velcro strips (9a) on the upper side of the
cleaning pad, to the 'hook' velcro pads (4a) on the
underside of the SteaMitt
Warning! The SteaMitt
should not be used without fitting a
TM
cleaning pad.
Note: The SteaMitt
accommodates 3 types of cleaning pads
TM
of varying thickness. The thinnest can be used for cleaning 3D
forms such as taps etc. The thicker versions can be used for
larger flat areas.
become hot
TM
TM
(4) by attaching
TM
(4). Press down firmly.
TM
(Original instructions)
Use
Switching on and off
To switch the appliance on, press the ON/Off button (5). It
u
takes approximately 15 seconds for the SteaMitt
up.
Note: always have your hand inside the SteaMitt
press the steam button.
To produce steam, press the steam button (1) on top of
u
the unit.
To switch the appliance off, turn off the steam switch (1)
u
then press the ON/OFF button (5).
Caution! Always empty the SteaMitt
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
Hints for optimum use
General
For optimal cleaning results never use the SteaMitt
u
without first attaching a cleaning pad.
Do not use chemical cleaners or any other additives with
u
your SteaMitt
TM
Delicate surfaces, mirrors for example, should be cleaned
u
first while the pad is at its driest, thereby avoiding streaks.
Do not use the SteaMitt
u
as damage may be caused by the sudden change in
temperature.
Caution! It is important to monitor the water level in the water
tank (6). To refill the water tank and continue to sanitize/clean
turn the SteaMitt
TM
wall outlet, refill the water tank (6).
@
Warning! Always use the SteaMitt
E, with your hand inside the protective glove.
@
Warning! Never attempt to use the SteaMitt
gripping it externally as shown in figure F. This will result
.
in scalding.
@
Warning! Avoid using the SteaMitt
shown in figure H.
@
Warning! Should a problem occur during use, use the
quick release tab (8) to quickly remove the SteaMitt
from your hand as shown in figure I.
After use (Fig. E)
Turn the SteaMitt
u
(1) to off and then press the ON/OFF button (5).
Wait until the SteaMitt
u
Unplug the SteaMitt
u
Empty the water tank.
u
remove the cleaning pad (9) and wash it ready for next
u
use.
ENGLISH
water tank after use.
TM
.
on cold glass, such as windows
TM
'OFF'. Unplug the unit from the electrical
as shown in figure
TM
in tight corners as
TM
'OFF'. Turn the steam operation button
TM
cools down.
TM
from the electrical wall outlet.
TM
to heat
TM
before you
TM
TM
by
TM
TM
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fsh10sm-qs

Table des Matières