4
Operation
Figure 03
4.3
Switching on appliance
Please be sure to observe the safety information in section 2.
WARNING – Electric shock hazard:
•
Do not operate the appliance with wet hands.
•
Protect the appliance from splashing.
Switch on appliance at
1st
•
The appliance is now ready.
pilot lamp
The
flashes.
4.4
Making settings
4.4.1.
Setting drying time
Turn the
time control
1st
•
time control
The
can be reset at any time.
The appliance starts.
pilot lamp
The
is continuously lit.
•
In the case of short drying times under 15 minutes:
Set the
time control
to a higher value first of all (e.g. 30 minutes) and then turn it
back to the shorter time.
•
In the case of long drying times over 60 minutes:
time control
The
must be reset a number of times, allowing a maximum,
-
continuous hood running time of 120 minutes to be set.
After 120 minutes the appliance turns off automatically.
-
pilot lamp
The
flashes.
To put the appliance back into operation, turn the
-
back on again.
4.4.2.
Setting the temperature
Set the temperature on the
1st
•
The recommended basic setting is level 8.
4.4.3.
Setting the airflow
Set the airflow to level I or level II on the
1st
4.5
Switching off appliance
Switch off appliance at the
1st
pilot lamp
The
goes out.
•
Remove the plug according to section 4.1.2.
Clean appliance, if necessary, as described in section 5.
2nd
51
ON/OFF switch
.
to the required drying time.
temperature control .
airflow setting control .
ON/OFF switch
.
GB
ON/OFF switch
off and