KTM 470.13.014.000 Mode D'emploi page 4

Scope of supply:
1x 47013014000 brake caliper support for 260mm
Not included in the scope of supply:
1x 47009060200 front brake disk D=260mm 2006
1x 47013011000 front brake hose 1145mm 2006
1x 54813001000 hand brake cylinder, complete SX 2005
1x 59013015144 front brake caliper, complete Brembo 2000
2x 50213025000 banjo bolt M10x1x19
4x 42013026000 CU seal ring DIN7603-10x16x1.5
1x 306054 DOT 5.1 brake fluid
2x 0015080353 M8x35 HH collar screw A/F=10
4
LOCTITE 243
2
LOCTITE 243
Mounting
– Remove the front wheel
– Remove the brake disk
– Remove the front brake caliper and the brake fitting
– Mount the 260 mm brake disk with the special M6x13 screw A/F=8
Disassembling the brake caliper
– Remove the brake linings
– Pull the caliper and caliper adapter apart (rubber boot should stay on
– Unscrew the guide bolt [1] from the adapter
5
Assembling the brake caliper
– Screw the guide bolt on the milled adapter (Loctite 243 + 25Nm)
4
NOTE:
Apply copper paste to the two guild bolts if necessary
3
– Slide the adapter and caliper together again - make sure the boot is
1
– Mount the brake linings again
– Screw the brake caliper to the fork pad with the HH M8x35 collar screw
– Fit the brake line [5] as shown in the drawing (bent connector up -
– Add DOT 5.1 brake fluid (Motorex Brake Fluid) as described in the
10.9 (59009062013). (Apply Loctite 243 to the screw and tighten
to 10Nm)
caliper)
in place
[2], apply Loctite 243 and tighten to 25 Nm
brake pump) with the CU seal ring [3] and banjo bolt [4]. Tighten the
banjo bolt to 15 Nm
Owner's Manual and bleed