N = 4,700 Min; Laser Class; Installation And Setting - Meister MKS1500-1 Mode D'emploi

Important! Wear a breathing
mask!
Wear suitable protective
gloves.
Caution laser radiation.
Do not look into the beam
(Laser class 2)
Warning in accordance with
EN 60825­1
Do not dispose of with
household waste!
Idle revolutions
n : 4700 min ­1
0
P ermissible saw blade diam­
Ø: 190 mm
eter
Additional symbols and the associated
explanations as used in the text of these
instructions.
BJ: Year of construction
SN: Serial number
SN: XXXXX The first two underlined
numbers give the month of
manufacture.
7 – Installation and setting
CAUTION! Prior to all mounting
and setting work, wait for the
tool to come to a complete standstill
and pull the plug from the mains.
Parallel cutting (Figure 2)
1. Undo the locking screw (6).
2. Adjust the parallel stopper (17)
according to the scale, pay attention
50
to the width of the saw blade
5453700-Handkreissaege_man.indd 50 5453700-Handkreissaege_man.indd 50
3. Tighten the fixing screw (6) again.
CAUTION! Make a test cut using
a piece of waste wood.
Notch A – vertical cut 90°
Notch B – angled cut 45°
Setting the cutting depth (Figure 3)
1. Undo the locking lever on the cutting
depth regulator (14).
2. Swivel the saw shoe (7) down.
3. Set the cutting depth using the scale
(13). Tooth tips must protrude approx­
imately 2 mm out of the wood.
4. Tighten the locking lever (14) up
again.
Adjusting the saw shoe (angled cut)
(Figure 4)
1. Undo the locking screw on the cutting
depth regulator (5).
2. Set the saw shoe using the cut­
ting angle scale (4) to the required
degrees 0/90°– 45°.
3. Tighten the locking screw.
Changing the saw blade
(Figures 5a + b)
1. Set the cutting depth to the smallest
value.
2. Use the lever (10) to push the pendulum
protective cover (8) as far up as it will
go, hold it and, at the same time, press
and hold the saw spindle lock (16).
3. Using the Allen wrench (19), undo the
hexagonal screw (9) anti­clockwise and
remove the flange.
09.07.20 11:28 09.07.20 11:28