Product Overview; Using The Tool; Intended Use - Pattfield Ergo Tools PE-1500 MNF Mode D'emploi

Product overview

1 Auxiliary handle
2 Housing
3
Flange cover
4
Flange cover screw
5 Diamond wheel
6 Lock off button
7 Cutting depth setting screw
8 Cutting depth scale
9 Base plate
10 Main handle
11 On / Off switch
12 Spindle lock button
13
Dust extraction port
14
Guidance roller

Intended Use

Connected to a suitable dust collection sys-
tem, the tool is intended for cutting or slotting
mineral materials such as brickwork without
the use of water. The tool is not intended for
commercial use.
Any other use or modification to the tool is
considered as improper use. The producer is
not responsible for any damage or injuries that
may result of it.
AUXILIARY HANDLE
1 Screw the auxiliary
auxiliary handle connector.
For safe working conditions, make
sure the auxiliary handle is always
mounted at the tool.
86 EN

Using the tool

1. Make sure a suitable dust collection sys-
2. To switch on the tool, press and hold the
3. Wait until the tool has reached maximum
4. Make sure the base
5. To switch off the tool, release the on / off
Notch width
handle 1 into the 2
tem is attached to the dust extraction
port 13.
lock off button 6. Then press and hold the
on / off switch 11.
speed. Slowly push the tool into and for-
ward the wall.
plate 9
tact with the wall.
switch 11.
8 mm 12 mm
20 mm 24 mm
DUST COLLECTION
Attach a suitable vacuum cleaner to
the dust extraction port 13.
Never use the tool without a dust
collection system.
is in full con-
16 mm
28 mm