Product Overview; Using The Tool; Intended Use - Pattfield Ergo Tools PA-2000HP Notice Originale

Product overview

1 Heat nozzle
2 Ventilation slots
3
On / Off heat selection switch
4
Grip
5 Power cord
6 Reflector nozzle
7 Reducer nozzle
8 Protector nozzle
9 Flat nozzle

Intended Use

The tool is intended for paint removal, for
warming (e.g. heat-shrinkable sleeves) and for
reshaping and welding of plastics. It may also
be used for detaching glued connections. The
tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
COOLING
1 After use set the heat selection
to 0 to switch the tool off.
Warning! The heat nozzle can be
very hot after use. Never touch it.
Danger of burns.
70 EN

Using the tool

1. If necessary, fit the required nozzle
depending on the type of work.
2. To switch on the tool, slide up the heat
selection switch
temperature.
3. Make sure your workpiece can not slip.
Start working, while holding the tool
firmly.
4. If necessary, remove paint or varnish with
a scraper.
5. Set heat selection
the tool off.
Caution! Do not inhale the resulting
vapors. Wear proper equipment to
protect your respiratory tract.
switch 3 2 Place the heat gun down on its end on
a level surface, with the nozzle point-
ing upwards.
6-9
3
and set the desired
switch 3 to 0 to switch