Pattfield Ergo Tools PE-1500 MNF Mode D'emploi page 89

CUTTING DEPTH
1 Loosen the cutting depth setting
screw 7 and set the desired cutting
depth at the cutting depth scale 8.
Caution! Make sure the tool is
switched off and unplugged.
NOTCH WIDTH
1 The tool can be set up to different notch
widths from 8 mm to 28 mm.
Caution! Make sure the tool is
switched off and unplugged.
POSITIONING
1 Place the front edge of the base
and the guidance roller 14
The diamond wheel must not be in con-
tact with the wall.
WHEEL REPLACEMENT
1 Remove the auxiliary handle
open the flange cover 3.
Caution! Make sure the tool is
switched off and unplugged and
wear protective gloves.
3 Insert a new diamond wheel assembly
into the tool.
Caution! Observe that the rotation
direction of the diamond wheels
corresponds with the indication on the tool.
2 The base
to your setting. Securely thighten the
cutting depth setting screw 7.
2 See section WHEEL REPLACEMENT to
set up the different wheel assemblies
described in NOTCH WIDTH on the left
page and install accordingly.
plate 9 2 Push the tool forward along the wall by
on the wall. use of the guidance
base
wall.
Caution! Remove the tool from the
wall if it has come to full stop.
1 and 2 Press the spindle lock button 12.
Loosen the wheel flange with the two-
pin spanner and remove the diamond
wheel assembly.
4 Press the spindle lock button 12, tight-
en the wheel flange with the two-pin
spanner and close the flange cover 3.
Caution! The flat surface of the
flange must point outwards.
plate 9 is moving accordingly
roller 14
plate 9 is in full contact with the
while the
EN 87