Help In Case Of Malfunctions - Lenz Digital plus LZV200 Manuel D'utilisation

50

13 Help in case of malfunctions

Fault
LZV200 is not ready for
work (no LED is on).
The lower LED flashes
slowly.
LZV200 is ready to work
(upper and lower red LEDs
on), locomotives do not run,
points and signals can not
be switched.
Your notes:
Possible cause
Electric power supply is
interrupted. Transformer
mains-plug not plugged in.
Probably there has been a
short-circuit on the track
system.
There is overloading
or
The distribution voltage of
the transformer is too low
because the load is too
high.
The connection of the
amplifier and the track and /
or the switch decoders is
interrupted (terminals J and
K not connected).
Information LZV200
Elimination of problem
Check wiring between
transformer and LZV200,
plug in transformer mains-
plug.
Deal with the short-circuit.
Divide the system into
several coverage areas and
supply them with additional
amplifiers / transformers.
Check and correct the
connections.