Zolia Teach'n Learn Mode D'emploi page 4

How to Use
Note: Please charge before using the product!
● Charge the remote transmitter:
➢ Connect the charger cable to the charging port.
➢ Plug the charger into a standard outlet.
➢ The icon of the battery will flash during charging and be solid when charging is complete.
To turn the Transmitter on and off
➢
➢ Press the power button to turn on /off the Transmitter. The backlight on/off.
➢ The backlight will stay for about 30 seconds. if no operation then backlight off.
● Charge the collar receiver:
➢ Open the rubber cover, connect the receiver to a charger into a standard socket.
➢ The LED flash light on the receiver turns red when charging.
➢ Once the receiver is fully charged, the red LED flash light will turn off automatically.
Warm Notice
When the receiver is turned on,press the power button twice quickly to feedback the power:
Receiver beeps 5 times,representing 100% (80-100%)
Receiver beeps 4 times,representing 80% (60-80%)
Receiver beeps 3 times,representing 60% (40-60%)
Receiver beeps twice,representing 40% (20-40%)
Receiver beeps once,representing 20% (1-20%)
● To turn the Receiver Collar on
Press the power button once, the receiver will have a short"beep" sound, now the receiver is turned
on. And the red LED light will flash one time every 8 seconds
● To turn the Receiver Collar off.
Press the On/Off Button once, the receiver will have a "beep" sound and no red LED light flash any
more.
Warm Notice
Charge the remote transmitter and receiver at least 2 hours for the first charging.
The collar cannot receive any signals while it is charging
The receiver will turn off automatically when battery energy is low after 10 seconds "beep" sound.
This product is rechargeable. In order to keep it continuous use,please charge it once a month if it is
not used.
● How to pair the Transmitter and Receiver
Turn on the remote and select one of the dog channels by pressing the CH button.
➢
➢ Adjust the levels by pressing"+" or"-" button (ensure the level is above 1).
➢ Turn on the receiver, the receiver will have a short "beep" sound, and the red LED light will
flash one time every 8 seconds.
➢ Hold the power button of the receiver for 2 seconds again, the indicator light will be fast
flashing for 10 seconds, press the function button(static stimulation/vibration/ tone, any one of
them) within 10 seconds. Then when you press the function button, the receiver will emit
corresponding sound, vibration and static stimulation. Confirm the pairing is successful.
If you have multiple receivers,simply choose a different channel and pair as per the same
instructions.
The remote and receiver(s) should now be paired.Pairing is necessary to control the
➢
receiver.You should then test each of the functions before attaching the collar to your pet.
5
4