Astralpool VICTORIA PLUS SILENT Manuel D'installation Et Maintenance page 4

WARNINGS DURING INSTALLATION AND ASSEMBLY WORK
- In cases of junction box connections only: when connecting the electrical wiring to the mo-
tor, check the layout inside the connection box and make sure there are no pieces of wiring
inside after it has been closed and that the earthing conductor is correctly connected. Con-
nect the motor in line with the wiring diagram attached to the machine.
- In cases of junction box connections only: make sure that the electrical wiring connections
to the terminal box are well mounted and screwed tightly to the connection terminals.
- The unit should be connected to an alternating current supply (see data on the pump's
plate) with an earth connection, protected by a residual current device (RCD) with a rated
residual operating current that does not exceed 30 mA.
- Ensure the seal of the motor's junction box is properly tted to prevent water getting in.
Likewise, position and tighten the gland inside the cable duct of the junction box.
- Make sure that water is unable to enter the motor or the live electrical parts.
- Where the intended use is not as indicated, additional technical adaptations and regulations
may apply.
WARNINGS DURING START UP
- Before starting the machine, check the calibration of the electric protection devices on the mo-
tor and that the protection against electrical and mechanical contacts is correctly positioned and
secure.
NOTE
The pool should not be used while the pump unit is running.
Do not use the pump if anyone is in contact with water.
WARNINGS DURING ASSEMBLY AND MAINTENANCE WORK
- Follow local installation regulations when assembling and installing the pumps.
- Make sure that water is unable to enter the motor or the live electrical parts.
- Avoid contact at all times - even accidentally - with moving parts while the unit is running and/or
before it comes to a complete standstill.
- Wait for the unit to come to a halt before handling it.
- Before any electrical or mechanical maintenance operation, disconnect the unit from the power
supply and block the start-up devices.
4 Installation and general maintenance manual - POOL PUMPS