Technical Data; Before Use - Hilti AG 500-12D Mode D'emploi Original

Suitability of discs for the equipment used
Item Equipment
A Guard
B Front cover (in
combination with
A)
C DG-EX 125/5" dust
hood for grinding
D DC-EX 125/5"C dust
hood for cutting (only
in conjunction with A)
E Side handle
F DCBG 125 hoop
handle (optional for
E)
G Clamping nut (not for
use with accessories
with integrated
thread)
H Clamping flange
(not for use with
accessories with
integrated thread)
I Kwik lock (optional
for G)
J Clamping nut for
abrasive resin-fiber
disc
K Support plate
L Guard type 27
5

Technical data

For rated voltage, rated current, frequency and/or input power, refer to the country-specific type
identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the device. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the device.
Maximum disc diameter
Drive spindle thread
Weight
6

Before use

CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and when
troubleshooting.
2143517
*2143517*
Printed: 20.04.2018 | Doc-Nr: PUB / 5300553 / 000 / 01
AC­D AG­D, DG-CW
AF­D, (SPX,
AN­D SP, P)
X X X
X — —
— — X
— — —
X X X
X X X
X X X
X X X
X X —
— — —
— — —
— — —
DC-TP, AP-D 3CS,
DC-D 4CS,
(SPX, 3SS,
SP, P) 4SS
X X X
X — —
— — —
X — —
X X X
X X X
X — —
X — —
X — —
— X —
— X —
— — —
AG 500-12D
5 in
5/8"-11
5.7 lb
(2.6 kg)
AG-D
type 27
—
—
—
—
—
—
—
—
—
—
—
X
English 9