Kübler Codix 130 Instructions D'utilisation page 9

1.11 Failure possibilities and causes
Impossible to use the keys:
• Key lock input activated
Counter does not count:
• Wrong or reversed wiring of the counting input
• Setting of an input signal not matching the pulse gen-
erator
• Polarity (NPN/PNP) reversed
• No ground connection between the pulse generator
and the counter
• Maximum counting frequency exceeded
• Signal levels do not reach the switching threshold of
the counter
Overview
Model Operating mode
6.130.012.8x0 Count
6.130.012.8x2
6.130.012.8x3
6.131.012.8x0 Cnt.Dir/Up.Dn
6.131.012.8x1
6.131.012.8x3 Up.Dn
6.132.012.8x3 Cnt.Dir
6.133.012.8x0 Quad/Quad2
6.133.012.8x1
Table 1
DC input modes:
Count: Fast and slow counting inputs
INP A: Fast counting input
INP B: Slow counting input
Cnt.Dir: Counting and counting direction input
INP A: Counting input
INP B: Counting direction input
Up.Dn: Differential counting input
INP A: Adding counting input
INP B: Subtracting counting input
Quad: Phase discriminator input
INP A: 0° counting input
INP B: 90° counting input
Quad2: Phase discriminator input with
pulse doubling
INP A: 0° counting input
INP B: 90° counting input
Each edge of INP A is counted.
If, despite all, your device still does not operate, contact
your local representative or call us directly for technical
support.
When sending your device back, please attach a short
description of the failure, of the programming and of the
connection diagram, in order to allow us to reproduce a
possibly existing defect and to repair your device as
quickly as possible.
Counting inputs
INP A
00 ... 0,7 V DC NPN
04 ... 30 V DC PNP
10 ... 260 V AC/DC AC/DC
00 ... 0,7 V DC NPN
04 ... 30 V DC PNP
10 ... 260 V AC/DC AC/DC
10 ... 260 V AC/DC AC/DC
00 ... 0,7 V DC NPN
04 ... 30 V DC PNP
Options:
AC input modes:
Count:
Cnt.Dir:
Up.Dn:
INP B
07 kHz 00 ... 0,7 V DC
12 kHz 00 ... 0,7 V DC
30 Hz 10 ... 260 V AC/DC
07 kHz 00 ... 0,7 V DC
12 kHz 04 ... 30 V DC
30 Hz 10 ... 260 V AC/DC
30 Hz 10 ... 260 V AC/DC
03 kHz 00 ... 0,7 V DC
06 kHz 04 ... 30 V DC
x = 5: no backlight
x = 6: with backlight
Counting and reset inputs
INP A: AC/DC counting input
INP B: AC/DC reset input
Counting and counting direction input
INP A: AC/DC counting direction input
INP B: AC/DC counting input
Differential counting input
INP A: AC/DC subtracting counting input
INP B: AC/DC adding counting input
NPN
30 Hz
NPN
AC/DC 0–
NPN 07 kHz
PNP 12 kHz
AC/DC 30 Hz
AC/DC 30 Hz
NPN 03 kHz
PNP 06 kHz
3