Indel B BREEZE T30 Instructions D'utilisation page 10

Masquer les pouces Voir aussi pour BREEZE T30:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BRE EZE T 30 - T40 11 5V
A PPLY I N G TH E D R A F T
(see figure 04)
The draft is a device - consisting of two parts, A and B - which connects the door of the Minibar to the door
of the piece of furniture it is fitted into, both when opening and when closing.
To install the draft, proceed as follows:
• screw the part A onto the door of the Minibar;
• open the door of the Minibar by 90°;
• screw the part B, perfectly horizontal, to the inside of the leaf of the piece of furniture, and fit it into the
part A so it can work as a sliding guide;
• fasten the lower part of the refrigerator to the base of the cabinet containing it by means of the
brackets C.
R E VE R S I N G TH E D O O R O PE N I N G S I D E
(see figure 05)
In the built-in models, the door can be hooked to the door of the cabinet housing it through a special
towing device, which enables simultaneous opening (dragging system). In the case where the door opens
on the opposite side to the cabinet door, it can be reversed as follows:
• remove the cover D;
• undo the screws holding the pin E to the fridge structure;
• remove the cover F;
• screw the pin E into the position previously occupied by the cover F;
• reposition the cover D above the pin E and the cover F on the opposite side of the structure.
M AINTE NAN CE
• Regularly clean the inside and outside of the refrigerator using only warm water and a neutral
detergent.
• Subsequent to washing, rinse with clean water and dry thoroughly using a soft cloth.
• Do not use the following: special glass and mirror cleaning products, liquid, powder, or spray
detergents, alcohol, ammonia or abrasive products.
• If you are not using the minibar, we suggest cleaning it well inside and leaving the door ajar to ventilate
the interior.
In the event of failure or a technical fault, make sure that:
a) the plug is correctly plugged into the mains socket;
b) the mains voltage corresponds to the voltage shown on the TECHNICAL DATA table;
c) the temperature adjusting knob is not in the position "0";
d) the fridge is not near sources of heat or exposed to sunlight;
e) the refrigerator is installed in such a way, to respect the ventilation openings.
BREEZE T30-T40_(115V)_IM_20190429
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Breeze t40

Table des Matières