Crosscall X-POWER Mode D'emploi page 6

Thank you for your trust and for purchasing this accessory
from the X-LINK™* range
CHARGING THE X-POWER WITH THE USB-C CABLE:
1. Insert the USB-C cable and the appropriate charger.
2. During charging, the LED(s) indicate the level of charge reached, and the
blinking LED indicates the current level.
3. When the X-POWER is charged, all four LEDs remain on.
The X-POWER allows a maximum charging current of 5V/2.1A
Charge the battery fully every 3 months if not used for a long time.
CHARGING WITH THE X-LINK
1. Position the 2 X-LINK
2. Your mobile automatically magnetises and the charging process starts
The X-LINK™* function can only be used with Crosscall products equipped
with this charging system.
If your X-POWER is charging, and it is charging a device via X-LINK™*, then
you are recharging both products at the same time.
CHARGING WITH THE USB CONNECTOR
1. Connect your cable to the X-POWER's USB-A port and the device to be
charged
2. Charging starts.
PRECAUTIONS FOR USE:
WATERPROOFING
Always make sure you properly close the waterproof caps.
Do not attempt to charge your smartphone or accessories underwater
(neither with X-LINK
*Magconn Technology
4
* connectors face-to-face (smartphone and X-POWER)
TM
*, nor via the connectors).
TM
* MAGNETIC CONNECTOR
TM