Waeco MagicSpeed MS400 Instructions De Montage Et De Service page 58

MS-400.qxd 24/06/03 15:10 Page 58
Adjustment/training mode
Stop the vehicle to leave the SETUP program and press the SET button 4 times while the
brake is activated.
After each modification of the PPM setting, all previous INIT-settings are overwritten with
the factory default settings; however, the GAIN setting remains unmodified.
If cruise control now take over the speed too slowly or too jerkily, the INIT setting must be
performed. If cruise control works too slowly or jerkily in normal operation, the GAIN set-
ting must be performed manually.
If cruise control works too slowly or too jerkily in normal operation, the GAIN setting
must be performed manually.
4. INIT mode
You can adjust the sensitivity of the speed takeover inINIT mode.
If cruise control takes over the speed too slowly, the INIT value must be increased. If the
speed is taken over too jerkily, the INIT value must be decreased.
First start the SETUP-program to reach the INIT setting mode.
Now press the RES button three times while the brake is activated. You will hear a low
acoustic
signal as a confirmation of each keystroke. Release the brake. You will hear three high
acoustic signals as a confirmation after releasing the brake. If you do not hear three high
acoustic signals, the above-mentioned steps must be performed again.
Drive at cruise control at any speed you like above the minimum speed (40 km/h). Now
press the SET button
until you notice cruise control taking over the speed at which you are driving. Switch off
cruise control by activating the brake. Press the SET button again; cruise control should
now take over the speed gently. If this is not the case, you can increase the INIT value
using the SET button and decrease the value using the RES button. You will hear an
acoustic signal for each keystroke.
58