SYMPTOM
Pilot lights. No
Valve is not functioning
gas fl ow.
properly.
Manual override knob is
in the "MAN" position.
Remote is not
Receiver has low battery.
functioning.
Remote has low battery.
Error with synchronizing
receiver and remote.
Remote is too far away
from receiver.
Receiver is not
Low / Dead battery.
functioning
Receiver not
properly.
communicating properly.
Wire connector pins are
bent.
Valve wiring is damaged.
Motor is turning,
Reciever batteries are
frequent beeping
low.
occurs.
PROBLEM
-
-
-
-
-
-
-
-
-
-
-
TEST SOLUTION
Valve is on pilot fl ow. Turn to to the high setting,
doudle click the large fl ame button on the remote.
Replace valve. Do not overtighen the thermocouple.
Turn the knob to the "ON" position.
Replace batteries.
Replace batteries (4 AA batteries).
Reset receiver and remote.
Refer to "WIRING DIAGRAM" section.
Replace batteries (receiver and/or remote).
Hold reset button on the receiver and wait for 2
beeps. Release after second beep. Press the small
fl ame button on the remote within 20 seconds, you
will hear an additional beep (this signals that the
receiver has been successfully reset).
Straighten pins.
Replace valve.
Replace batteries.
29
42.31_3
W415-1198 / 05.24.13
EN