Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000029-001.book Page 15 Wednesday, February 16, 2011 8:27 AM
Notes on sanding.
Typical application: Dry sanding of wood and
painted surfaces.
When only one tip or corner of the sanding
sheet is worn, it can be removed again and
reattached turned by 120°.
Work with the entire surface of the sanding
plate, not only with the tip. Select a high oscil-
lating frequency. Sand with continuous
motion applying moderate pressure. Applying
overly pressure does not increase the rate of
removal, it only wears off the sanding sheet
faster.
Notes on sawing.
Typical application: Sawing thin steel sheet,
wood and plastic parts.
Handling the battery.
Charge batteries only in ambient tempera-
tures between 0 °C and 40 °C (32 °F–
104 °F). At the beginning of the charging
procedure, the battery temperature may not
exceed 45 °C (113 °F).
Battery charge-control indicator
(figure 11).
Press the button to activate the LED indica-
tion.
LED indicator Meaning
1 – 4 green
Percent-
LED
age of
charge
condition
Continuous
Battery is
red light
almost
empty
Red flashing
Battery is
light
not ready
for oper-
ation
The real percentage of the battery charge
condition is only indicated when the power
tool motor is stopped.
The electronics automatically switch off the
motor prior to the battery being deep dis-
charged.
Select a high oscillating frequency. Round saw
blades can be released and clamped offset
again, to allow for uniform wearing off.
When sawing and plunging, provide for good
removal of chippings by applying moderate
pendular motion.
Notes on scraping.
Typical application: Scraping off old coatings
or adhesive, removal of glued carpet, e. g., on
steps or other small/mid-sized surfaces.
Select a moderate to high oscillating fre-
quency.
Activity
Operation
Charge battery
Bring the battery
into the battery
operating-tem-
perature range,
then charge
en
15
Publicité
