Component Installation - Mopar KJ Mode D'emploi

Component Installation

1. Install Hood Safety Switch.
A. Using (2) of the supplied 1/4"
screws, secure hood safety switch
on driver's side rear corner of hood
per the diagram. Note: Wire exits
top of switch. Switch must be
bent at 45 degree angle.
B. Using a supplied 1/4" screw,
secure the ground lead from the
switch to the cowl as shown in the
diagram. The remaining wire will be
connected later.
C. Locate a visible area in the front of
the engine compartment to mount
the underhood warning sticker as
shown in the diagram.
2. Install Dipole Antenna
A. Mount dipole antenna to the
windshield above and to the right of
the rearview mirror and below the
black windshield trim.
B. Run the antenna wire above the
headliner to the driver's A-pillar.
Temporarily remove the A-pillar
rubber gasket and run the antenna
lead down through the left side
dash opening. Replace the rubber
gasket. Ensure the antenna is
securely tucked above the head-
liner and is not visible along the
entire length.
6