Component Installation - Mopar 82208995 Notice D'installation

Component Installation

1. Install Hood Safety Switch.
A. Using (2) of the supplied 1/4"
screws, secure hood safety switch
on driver's side rear corner of hood
per the diagram. Note: Wire exits
top of switch. Switch must be
bent at 45 degree angle.
B. Route the hood safety switch
wiring under the engine compart-
ment right side weatherstripping as
shown in the diagram.
C. Using a supplied 1/4" screw,
secure the ground lead from the
switch to the right side metal brace
as shown in the diagram. The
remaining wire will be connected
later.
D. Locate a visible area in the front of
the engine compartment to mount
the underhood warning sticker as
shown in the diagram.
2. Install Dipole Antenna
A. Mount dipole antenna to the
windshield above and to the right of
the rearview mirror and below the
black windshield trim.
B. Run the antenna wire above the
headliner to the driver's A-pillar.
Temporarily remove the A-pillar
rubber gasket and run the antenna
lead down through the left side
dash opening. Replace the rubber
gasket. Ensure the antenna wire is
securely tucked above the head-
liner and is not visible along the
6
entire length.