IKEA FÖRDELAKTIG Mode D'emploi page 5

ENGLISH
that the current carrying conductors become taut be-
fore the earthing conductor if the cord slips out of the
cord anchorage.
• The manufacturer will not be held liable for any dam-
ages resulting from incorrect or improper installa-
tion.
• Check that the mains voltage corresponds to that
indicated on the rating plate fixed to the inside of
the product.
• Means for disconnection must be incorporated in
the fixed wiring in accordance with the wiring rules.
• For Class I appliances, check that the domestic pow-
er supply guarantees adequate earthing.
• Connect the extractor to the exhaust flue through an
adequate pipe. Please refer to the purchasable ac-
cessories shown in the installation manual (if circular
pipe: minimum diameter 120 mm). The route of the
flue must be as short as possible.
• Connect the product to the power net by using an om-
nipolar switch.
• Regulations concerning the discharge of air have to be
fulfilled.
• Do not connect the extractor appliance to exhaust
ducts carrying combustion fumes (boilers, fireplaces,
etc.).
• If the extractor is used in conjunction with non-
electrical appliances (e.g. gas burning appliances),
a sufficient degree of aeration must be guaranteed
in the room in order to prevent the backflow of
exhaust gas. When the cooker appliance is used in
conjunction with appliances supplied with energy
other than electric, the negative pressure in the
room must not exceed
5