Defrost; Illumination Lamp - Grundig GFTU 13110 Manuel D'utilisation

5.3 Defrost

Increase in the thickness of the
ice that forms on the evaporator of
your refrigerator will decrease the
cooling efficiency of it.
Therefore, you must defrost the
ice when the thickness of the
ice layer around the evaporator
reaches to approximately 5 mm. It
is recommended to defrost the ice
when the refrigerator is not filled
too much or is empty.
Wrap the food in the refrigerator
by a few sheets of paper and keep
them in the coolest place possible
or in another refrigerator.
Turn the thermostat setting button
to "off" or unplug the power cable
in order to perform the defrosting.
Remove the drawers of your
refrigerator (it is not required to
remove the lid of the compartment
equipped with a lid). After some
time, the water that melts will
accumulate in the pool located at
the bottom of your refrigerator.
Remove the accumulating water by
means of a soft sponge or etc. and
dry the pool thoroughly.
Do not forget to turn the
thermostat setting button to a
position other than the "off" in
order to restart your refrigerator.
Operate your refrigerator for 2
hours while it is empty and its
doors are closed before replacing
your food into it.

5.4 Illumination lamp

To change the Bulb/LED used for
illumination of your refrigerator,
call your AuthorisedService.
The lamp(s) used in this appliance
is not suitable for household room
illumination. The intended purpose
of this lamp is to assist the user to
place foodstuffs in the refrigerator/
freezer in a safe and comfortable
way.
The lamps used in this appliance
have to withstand extreme physical
conditions such as temperatures
below -20 °C.
(only chest and upright freezer)
IT
DE
19