Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
Cut to Length
If necessary, cut the first channel to this length, making sure
■
the cut is square.
NOTE: Channels cut to shorter than 24" (60.96 cm) long
should not be used.
Mounting the Channels
1.
Drive First Screw
Holding the channel up in the desired location, drive a screw
■
through the top slot groove and into the center of the stud
nearest to the middle of the channel until it is flush with the
surface.
NOTE: If installing GearTrack
poured concrete, you may put construction adhesive on the
GearTrack
Channel before attaching it to the wall for extra
®
hold.
3.
Predrill Holes
If splitting occurs, you may find it necessary to predrill and
■
countersink the screw holes near channel ends with a
1/8" (3 mm) drill bit.
4
Channels on masonry block or
®
2.
Level the Channel
BUBBLE LEVEL
Check that the GearTrack
■
a second screw through the bottom slot groove and into the
center of the same stud as in the previous step.
4.
Drive Remaining Screws
Drive a screw in every slot at every stud location.
■
Channel is level, and then drive
®
Publicité
Table des Matières
