Maintenance Kit Instructions - Weston PRO-1100 Mode D'emploi

MAINTENANCE KIT INSTRUCTIONS

Some parts of the Vacuum Sealer may need replacing after repeated use. The
Vacuum Sealer Maintenance Kit will be necessary for the Vacuum Sealer to
properly function.
REPLACING THE OVAL VACUUM CHAMBER SEALS:
1. Turn "OFF" the Vacuum Sealer and remove the Power Cord from the electrical
outlet.
2. Make sure the unit is completely cool.
3. Open the Vacuum Lid.
4. Remove the Oval Vacuum Chamber Seal from the groove on the underside of
the Vacuum Lid.
5. Remove the Oval Vacuum Chamber Seal from the groove in the Plastic
Vacuum Chamber.
6. Set a new Oval Vacuum Chamber Seal on the groove in the Plastic Vacuum
Chamber. Work the seal into the groove with your fingers until done.
7. Position a new Oval Vacuum Chamber Seal into the groove in the Vacuum
Lid. Work the seal into the groove with your fingers until done.
REPLACING THE SEAL BAR TAPE:
1. Turn "OFF" the Vacuum Sealer and remove the Power Cord from the electrical
outlet.
2. Make sure the unit is completely cool.
3. Open the Vacuum Lid.
4. Pick at either end of the Seal Bar Tape covering the Seal Bar Heating Element
with a fingernail until it lifts slightly. Grasp the loose end and slowly pull
the Seal Bar Tape back over itself until fully removed.
5. Remove the backing from a new strip of Seal Bar Tape. Be careful not to
allow the Seal Bar Tape to contact anything including itself while the adhesive
side is exposed.
6. Hold one end of the Seal Bar Tape in each hand. Stick the left end of the Seal
Bar Tape to the flat area on the Plastic Vacuum Chamber just left of the Seal
Bar Heating Element. Apply the Seal Bar Tape from left to right over the Seal
Bar Heating Element until done. Make sure there are no wrinkles or folds in the
Seal Bar Tape once applied. The Seal Bar Tape should fully cover the Seal Bar
Heating Element.
14